Yamaha NPS 4500 Owner's Manual page 20

E. Starting and Operating the Generator
E.7 Wireless Hand-held Remote-Start Keyfob was created to conveniently allow
you to start/stop your Generator from a distance of fifty (50) meters (164'). See
Exhibit 6
• To start the Generator, press and hold the "START" button for more than one (1)
second and then release the button
• To stop the Generator, press and hold the "STOP" button for more than one (1)
second and then release the button
E.8 Using the Wireless Hand-held Remote-Start Keyfob for remote starting the
Generator See
Exhibit 6
The Keyfob you received with your RV will have its signals already matched to the
Generator during installation. However, if you replace the Keyfob battery, are using a
replacement Keyfob, or you lose your signal you will need to re-match the Generator
and the Keyfob's wireless signals
• To match signals connect the Generator with the RV battery source, turn the
Master 12 Volt Power Switch, inside the Generator Service Access Door, to the
"ON" position. See
• Press the Signal Match Set Button on the Remote Control Module and hold it for
more than three (3) seconds until the Signal Match Indicator Light on the Remote
Control Module stays on constant
• Release the Signal Match Set Button and press the "STOP" button on the Keyfob
(at this moment the Signal Match Indicator Light on the Remote Control Module
will blink one time and then stay on constant)
• Release the "STOP" button on the Keyfob and press the "START" button on the
Keyfob (at this moment the Signal Match Indicator Light on the Remote Control
Module will blink one time and then stay on constant)
• Release the "START" button on the Keyfob, press and hold the Signal Match Set
Button on the Remote Control Module until the Signal Match Indicator Light on
the Remote Control Module is off
• Start the Generator by pressing"START" on the Keyfob, then stop the Generator
by pressing "STOP" on the Keyfob to verify the signals have matched. If the
match is not made, repeat the above procedure, until the Keyfob and Generator
wireless signals are successfully matched
Exhibit 2
Page 20 of 30 Rev 1.7