Cisco ESW 500 Administration Manual page 216

Configuring Ports
Port Settings
ESW 500 Series Switches Administration Guide
-
100M —
Copper
-
1000M
— Copper (copper cable).
-
1000M
— ComboC (combo port with copper cable 3).
-
1000M
— ComboF (combo port with optic fiber cable).
-
1000M FiberOptics
connection.
•
Admin Status — Indicates whether the port is currently operational or non-
operational. The possible field values are:
-
Up — Indicates the port is currently operating.
-
Down — Indicates the port is currently not operating.
•
Current Port Status — Displays the port connection status.
•
Reactivate Suspended Port — Reactivates a port if the port has been disabled
through the locked port security option or through Access Control List
configurations.
•
Operational Status — Indicates whether the port is currently active or inactive.
•
Admin Speed — Displays the configured rate for the port. The port type
determines what speed setting options are available. You can designate Admin
Speed only when the port auto-negotiation is disabled.
•
Current Port Speed — Displays the current port speed.
•
Admin Duplex — Defines the port duplex mode. This field is configurable only
when auto negotiation is disabled, and the port speed is set to 10M or 100M.
This field cannot be configured on EtherChannels. The possible field values
are:
-
Full
— Indicates that the interface supports transmission between the
device and the client in both directions simultaneously.
-
Half
— Indicates that the interface supports transmission between the
device and the client in only one direction at a time.
•
Current Duplex Mode — Displays the port current duplex mode.
•
Auto Negotiation — Enables or Disables Auto Negotiation on the port. Auto
Negotiation enables a port to advertise its transmission rate, duplex mode and
flow control abilities to its partner.
•
Current Auto Negotiation — Displays the Auto Negotiation status on the port.
— Indicates the port has a fiber optic port
6
205