Standby Name - Cisco Catalyst 6500 Series Command Reference Manual

standby name

standby name
To configure the name of the standby group, use the standby name command. Use the no form of this
command to disable the name.
Syntax Description
group-name
Defaults HSRP is disabled.
Command Modes
Subinterface configuration submode
Command History Release
SSL Services Module
Release 2.1(1)
SSL Services Module
Release 3.1(1)
Usage Guidelines
The group-name argument specifies the HSRP group.
Examples
This example shows how to specifiy the standby name as SanJoseHA:
ssl-proxy (config-subif)# standby name SanJoseHA
ssl-proxy (config-subif)#
Related Commands
ip mobile home-agent redundancy (refer to the Cisco IOS Release 12.2 Command Reference)
Catalyst 6500 Series Switch SSL Services Module Command Reference
2-104
standby name group-name
no standby name group-name
Name of the standby group.
Modification
Support for this command was introduced on the Catalyst 6500 series
switches.
The command mode for this command was changed from Proxy-VLAN to
Subinterface.
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
OL-9105-01