Management Vlan - Cisco Catalyst 2950 Software Manual

Menus and Toolbar
Table 2-10 Menu Bar (continued)
Menu-Bar Options
Port
2
Port Settings
Port Search
1
Port Security
2
EtherChannels
2
SPAN
2
Protected Port
2
Flooding Control
VLAN
2
VLAN
1
(guide mode available )
2

Management VLAN

2
VMPS
Reports
Inventory
Port Statistics
Bandwidth Graphs
Link Graphs
Link Reports
Resource Monitor
System Messages
Catalyst 2950 Desktop Switch Software Configuration Guide
2-18
Task
Display and configure port parameters on a switch.
Search for a port through its description.
Enable port security on a port.
Group ports into logical units for high-speed links between switches.
Enable Switch Port Analyzer (SPAN) port monitoring.
Configure a port to prevent it from receiving bridged traffic from another port on the
same switch.
Block the normal flooding of unicast and multicast packets, and enable the switch to
block packet storms.
Display VLAN membership, assign ports to VLANs, and configure 802.1Q trunks.
Display and configure the VLAN Trunking Protocol (VTP) for interswitch VLAN
membership.
Change the management VLAN on the switch.
Configure the VLAN Membership Policy Server (VMPS).
Display the device type, software version, IP address, and other information about a
switch.
Display port statistics.
Display graphs that plot the total bandwidth in use by the switch.
Display a graph showing the bandwidth being used for the selected link.
Display the link report for two connected devices. If one device is an unknown device or
a candidate, only the cluster-member side of the link displays.
Display masks for ACL and QoS policy maps.
Display the most recent system messages (IOS messages and switch-specific messages)
sent by the switch software.
This option is available on the Catalyst 2950 or Catalyst 3550 switches. It is not available
from the Catalyst 2950 switches. You can display the system messages of the
Catalyst 2950 switches when they are in a cluster where the command switch is a
Catalyst 2950 switch running Cisco IOS Release 12.1(6)EA2 or later. For more
information about system messages, see
Chapter 2
6
Appendix B, "System Messages."
Getting Started with CMS
78-11380-03