Error Message Traceback Reports; Error Messages And Recovery Procedures; Chassis Message; Cmp Messages - Cisco Catalyst 2950 Software Manual

Appendix B System Messages

Error Message Traceback Reports

Some messages describe internal errors and contain traceback information. This information is very
important and should be included when you report a problem to your technical support representative.
This is a sample message includes traceback information:
-Process= "Exec", level= 0, pid= 17
-Traceback= 1A82 1AB4 6378 A072 1054 1860

Error Messages and Recovery Procedures

This section lists the switch system messages by facility. Within each facility, the messages are listed by
severity levels 0 to 7: 0 is the highest severity level, and 7 is the lowest severity level. Each message is
followed by an explanation and a recommended action.

Chassis Message

This section contains the Chassis error message.
Error Message CHASSIS-5-BLADE_EXTRACT
Explanation
Recommended Action

CMP Messages

This section contains the Cluster Membership Protocol (CMP) error messages.
Error Message CMP-5-ADD: The Device is added to the cluster (Cluster Name:[chars],
CMDR IP Address [inet])
Explanation
and [inet] is the Internet address of the command switch.
Recommended Action
Error Message CMP-5-MEMBER_CONFIG_UPDATE: Received member configuration from member
[dec]
Explanation
the member number.
Recommended Action
78-11380-03
The message means that the hot-swap switch has been pressed.
Extract the module.
The message means that the device is added to the cluster: [chars] is the cluster name,
No action is required.
This message means that the command switch received a member configuration: [dec] is
No action is required.
Catalyst 2950 Desktop Switch Software Configuration Guide
Error Message Traceback Reports
B-3