Cisco 520 Hardware Installation Manual page 40

Typical Installation
To install a Cisco Secure Router 520 ADSL-over-POTS router, follow these steps:
If you have a wireless router, first connect the radio antenna to the router. See the
Step 1
Antenna to a Wireless Router" section on page
Connect the server, PC, or workstation to the router. See the
Step 2
section on page
(Optional) If you need to connect more than four PCs, connect an external Ethernet switch to the router's
Step 3
built-in switch. See the
Connect the ADSL line. See the
Step 4
Connect the AC adapter to the router. See the
Step 5
To configure the router software by using the command-line interface (CLI) or to troubleshoot problems,
Step 6
connect a terminal or PC to the console port. See the
section on page
(Optional) To use the console port as a backup link to the WAN port in case the ADSL service goes down,
Step 7
connect an analog modem to the console port. See the
Console Port" section on page
Cisco Secure Router 520 Series Hardware Installation Guide
4-4
4-6.
"Connecting an External Ethernet Switch (Optional)" section on page
"Connecting an ADSL Line—ADSLoPOTS Port" section on page
4-14.
4-14.
3-1.
"Connecting a Server, PC, or Workstation"
"Connecting the AC Adapter" section on page
"Connecting a Terminal or PC to the Console Port"
"Connecting an Asynchronous Modem to the
Chapter 4 Router Installation
"Connecting a Radio
4-7.
4-9.
4-12.
OL-12892-01