Connecting An Xdsl Line - Cisco 860 Series Hardware Installation Manual

Chapter 3 Connecting the Router

Connecting an xDSL Line

Warning Hazardous network voltages are present in WAN ports regardless of whether power to the unit
is OFF or ON. To avoid electric shock, use caution when working near WAN ports. When
detaching cables, detach the end away from the unit first. Statement 1026
Cisco Systems DSL WAN Interfaces are tested for compliance with regulatory standards such as FCC
Caution
Part 68, ITU-T K.21, IEC 61000-4-5, and CSA/EN/IEC/UL 60950-1. These standards assume Primary
Protection devices protect the Customer Premise Equipment (CPE). These devices are normally
installed by the service provider, local exchange carrier or qualified service person and are located at the
telecom service provider entrance, network interface box, or demarcation point. See
likely location of the primary protection device. The primary protection device must be suitable for the
xDSL interface employed. Please contact your sales team or qualified service person for further
information and installation.
To reduce the risk of fire, use only No. 26 AWG or larger (e.g., 24 AWG) UL Listed or CSA Certified
Caution
Telecommunication Line Cord.
IMPORTANT SAFETY INSTRUCTIONS
Warning
When using your telephone equipment, basic safety precautions should always be followed to
reduce the risk of fire, electric shock and injury to persons, including the following:
- Do not use this product near water - for example, near a bathtub, washbowl, kitchen sink or
laundry tub, in a wet basement or near a swimming pool.
- Avoid using a telephone (other than a cordless type) during an electrical storm. There may be
a remote risk of electric shock from lightning.
- Do not use the telephone to report a gas leak in the vicinity of the leak.
- Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a
fire. They may explode. Check with local codes for possible special disposal instructions.
SAVE THESE INSTRUCTIONS
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16193-07
Connecting an xDSL Line
Figure 3-22 for the
3-23