Table of Contents
Advertisement
Mounting
The mounting process typically requires modi-
fication of your table saw. Be sure to read the
Important Notice on Page 1.
To make the process easier, we strongly recom-
mend that you have another person to help you.
Before beginning the mounting process, refer to
Needed for Setup and gather all listed items.
To mount system:
1.
DISCONNECT SAW FROM POWER!
2.
Tape mounting template to table saw cabinet
rear (see Figure 4). Baseline must be parallel
with and 4
⁄
" from table surface.
1
2
4
⁄
"
1
2
Figure 4. Mounting template taped to table
saw cabinet rear with baseline 4
surface.
3.
Use center punch to mark (4) mounting holes
indicated on mounting template.
Model T32428 (Mfd. Since 11/21)
Baseline
⁄
" below table
1
2
4.
Remove mounting template and drill (4)
holes at locations marked in Step 3 (see
Figure 5).
Tip: Drill pilot holes using smaller bit before
enlarging to
⁄
for best results.
11
32
5.
Open cabinet access panel or door to insert
(2) M8-1.25 mounting stud pads through
holes (see Figure 5).
Mounting Stud
Pads
Figure 5. Mounting stud pads inserted.
Note: If table saw has no cabinet access
panel or door, you may need to turn machine
on its side and access holes from underneath
machine.
Lifting heavy machinery
or parts without proper
assistance or equipment
may result in strains, back
injuries, crushing injuries,
or property damage.
⁄
"
11
32
-9-
Advertisement
Table of Contents
