Cisco Network Device 2800 Introduction Manual page 60

Installing Modules and Interface Cards
Quick Start Guide: Network Modules for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700
•
Series Routers and Cisco 2800 Series
Cisco Network Modules Hardware Installation Guide
•
For HWICs and VICs:
Installing Interface Cards in Cisco 2800 Series Routers
•
Quick Start Guide: Interface Cards for Cisco 1600, 1700, 2600, 3600, and 3700 Series ---and Cisco
•
2800 Series
Cisco Interface Cards Installation Guide
•
The chassis slots for network modules and interface cards are identified in
and Figure
If the required network modules, interface cards, and internal field-replaceable units (FRUs) are already
installed, proceed to the
If you need to remove or install any internal FRUs, see the
(FRUs)" section on page
Figure 1
7
8
1 Slot 0 (VIC or VWIC, voice only—no PRI) 8
2 Slot 1 (WIC, VIC, VWIC, or HWIC)
3 Slot 2 (WIC, VIC, or VWIC)
4
Slot 3 (WIC, VIC, VWIC, or HWIC)
5
Console port
6 Fast Ethernet ports and LEDs
System LEDs
7
Chassis Installation Procedures for Cisco 2800 Series Routers
2
4.
"Setting Up the Chassis" section on page
4.
Chassis Slot Locations in Cisco 2801 Routers
6 4
5
9 11 12 13
10
"Installing Internal Field-Replaceable Units
3
14
Auxiliary power (AUX/PWR) LED
9 Universal serial bus (USB) port
10 AIM/PVDM LEDs
11 Auxiliary port
12 CompactFlash (CF) LED
13 External CompactFlash memory card slot
Removable center card guides to allow
14 double-wide HWIC-D installation
Figure 1, Figure 2,
5.
2 1
14
Figure 3,
OL-5786-03