Cisco Network Device 2800 Introduction Manual page 107

Table 3 System Error and Recovery Messages (continued)
LED Type LED Color
— —
AUX/ Amber
PWR
AUX/ Green
PWR
— —
— —
OL-5789-01
Message, Meaning, and Recommended Action
Error:
%ENVMON-3-FAN_FAILED: Fan fan-number not rotating.
Explanation:
The specified fan (1, 2, or 3) is not rotating at the desired speed.
Recovery:
Make sure that the fan power cable is properly attached to the mainboard fan power connector.
If the problem persists, contact your technical support representative.
Message:
%ENVMON-5-48V_STATUS: -48V supply failed
Explanation:
The –48 V power supply has failed.
Recommended action:
Replace the power supply. Refer to the
and Upgrading Internal Modules in Cisco 2800 Series
Message:
%ENVMON-5-48V_STATUS: -48V supply OK
Explanation:
The –48 V power supply is operating normally.
Recommended action:
Message is informational only.
Message:
%ENVMON-5-RPS: Redundant power supply attached
Explanation:
Redundant power supply was connected to the router.
Recommended action:
Message is informational only.
The Cisco 2801 does not support RPS. This message is not applicable to the Cisco 2801.
Note
Message:
%ENVMON-5-RPS: Redundant power supply removed
Explanation:
Redundant power supply was disconnected from the router.
Recommended action:
Message is informational only.
The Cisco 2801 does not support RPS. This message is not applicable to the Cisco 2801.
Note
"Replacing the Power Supply"
Routers" online document.
Troubleshooting Cisco 2800 Series Routers
System Messages
section of the "Installing
9