Cisco Network Device 2800 Introduction Manual page 108

System Messages
Table 3 System Error and Recovery Messages (continued)
LED Type LED Color
AUX/ Amber
PWR
AUX/ Green
PWR
AUX/ Green
PWR
AUX/ Green
PWR
Troubleshooting Cisco 2800 Series Routers
10
Message, Meaning, and Recommended Action
Message:
%ENVMON-5-RPS_STATUS: RPS standby/faulty
Explanation:
Redundant power supply has failed or has gone into standby mode.
Recommended action:
Check the redundant power supply. If faulty, disconnect it from the router and contact your
Cisco technical support representative.
The Cisco 2801 does not support RPS. This message is not applicable to the Cisco 2801.
Note
Message:
%ENVMON-5-RPS_STATUS: RPS not available
Explanation:
Redundant power supply is connected to the router, but is not available to back up the internal
power supply.
Recommended action:
Message is informational only.
Note The Cisco 2801 does not support RPS. This message is not applicable to the Cisco 2801.
Message:
%ENVMON-5-RPS_STATUS: RPS in use
Explanation:
The router is receiving power from the redundant power supply.
Recommended action:
Message is informational only.
Note The Cisco 2801 does not support RPS. This message is not applicable to the Cisco 2801.
Message:
%ENVMON-5-RPS_STATUS: RPS ready/available
Explanation:
Redundant power supply is connected to the router and is powered up, but the router is not
receiving power from the redundant power supply.
Recommended action:
Message is informational only.
Note The Cisco 2801 does not support RPS. This message is not applicable to the Cisco 2801.
OL-5789-01