Cisco Network Device 2800 Introduction Manual page 127

Blank Panels for HWIC Slots
The high-speed WAN interface card (HWIC) hardware kit for Cisco 2800 series routers contains two
blank panels. Each panel covers one single-wide HWIC slot.
Install blank panels over empty HWIC slots as follows:
•
•
Related Product Documentation
The following documentation is related to your product. This documentation was not shipped with your
product, but you can access it online at Cisco.com.
•
OL-5791-01
Single-wide slot—Attach a blank panel and tighten the two screws.
Double-wide slot—Install a slot divider as described in the
on Cisco 2811, Cisco 2821, and Cisco 2851 Routers"
tighten the two screws in each blank panel.
Cisco Network Modules and Interface Cards Regulatory Compliance and Safety Information
"Installing Slot Dividers in HWIC Slots
section; then install two blank panels and
Installing Interface Cards in Cisco 2800 Series Routers
Related Product Documentation
7