Cisco Network Device 2800 Introduction Manual page 177

Installing an ILP Supply
The ILP supply has three power connectors, as shown in
Figure 49
1
2
Insert the AC-input power supply into the chassis from the front.
Step 1
Step 2 Install the two power supply retaining screws. Torque to 8 to10 in-lbf (0.9 to 1.1 N-m). See
Step 3 Connect the primary power supply cable to the power supply. Make sure that the locking feature on the
power supply end snaps into position. See
Step 4 Connect the secondary power supply cable to the power supply. Make sure that the locking feature on
the power supply end snaps into position. See Figure
Step 5 Connect the ILP cable to the supply. Make sure that the locking feature on the power supply end snaps
into position. You must also route the ILP cable through the hooks on the power supply and chassis.. See
Figure
OL-5792-04
ILP Supply
Primary power connector
Secondary power connector
50.
Figure
3 ILP connector
Figure 46.
Figure
Installing and Upgrading Internal Modules in Cisco 2800 Series Routers
Replacing the Power Supply
49.
3
1
2
48.
Figure 43.
49