Table of Contents
Advertisement
Introduction
About this Guide
About this Guide
Recommended Installation Sequence
NSS2000 Getting Started Guide
The Getting Started Guide contains the step-by-step details for getting your NSS
up and running for the first time---from hooking up the hardware to doing the basic
configuration steps to get the NSS running. Users are shown how to log into the
NSS to access storage.
Follow the NSS installation steps to set up and configure the device. They provide
out-of-the-box instructions. You can find detailed instructions for each step in the
remaining sections of this guide.
•
Set up the hardware
-
Step 1: Install the disk drives. If your device already has disk drives
installed, skip this step.
-
Step 2: Connect the Ethernet cable.
-
Step 3: Connect the power.
•
Configure the NSS
(NSS)"):
-
Step 1: Configure the Network Settings IF a DHCP server is not present.
(If there is a DHCP server, skip this step.)
-
Step 2: Log into the Configuration Interface
-
Step 3: Run the applicable configuration wizards.
-
Step 4: After you configure the NSS, save a copy of the configuration file
to a location on the NSS and to a USB key.
•
Instruct your users how to access the NSS, if applicable
"Instructing your End Users"
(Chapter 2, "Setting up the
(Chapter 3, "Configuring the Network Storage System
1
Hardware"):
(Chapter 4,
2
Hide quick links:
Advertisement
Table of Contents
