Honeywell GF505 Manual page 80

Programming
Secondary # Telco Primary Line Fault
Secondary # Telco Secondary Line Fault
Secondary # NAC #1 Fault
Secondary # NAC #2 Fault
Secondary # NAC #3 Fault
Secondary # NAC #4 Fault
Secondary # NAC #1 Disable
Secondary # NAC #2 Disable
Secondary # NAC #3 Disable
Secondary # NAC #4 Disable
Secondary # Charger Fault
Secondary # Comm Trouble Primary #
Secondary # Comm Trouble Secondary #
Secondary # Printer Fault
Secondary # ANN-Bus Fault
Secondary # Option Card Fault
Secondary # CS CALC Fault
Secondary # System Off Normal
Secondary # System Test Message
Secondary # System Abnormal Test Message
Secondary # Power Supply Sync Fault
Secondary # Upload/Download Request
Secondary # Upload Successful
Secondary # Download Successful
Secondary # Upload/Download Failed
Secondary # Voice EVAC Fault
Secondary # Power Supply Sync Fault
Trouble Call Limit (Dialer Runaway Prevention)
CENTRAL STATION
1=PRIMARY
2=SECONDARY
3=CALL LIMIT
Central Station Screen #2
To set the Trouble Call Limit, press 3 while viewing Central Station Screen #2. The following screen will be displayed.
Enter a value between 00 and 99, then press Enter to set the Call Limit to this value.
NOTE: Entering a value of 00 will disable the Trouble Call Limit allowing the DACT to call the Central Station an unlimited amount of times.
This is the factory default setting.
Service Terminal
DACT
1=SERVICE TERMINAL
2=SUPERV PHONE LINE
Onboard DACT Screen #2
80
Table 3.7 SIA-DCS Secondary # Event Codes (Continued)
The Call Limit option limits the number of DACT trouble calls to the Central Station, to a programmed
amount between 0 and 99, for each unique trouble within a 24 hour period. All call limit counters reset
(clear) at each midnight. Separate limit counters keep track of each unique type of trouble. Note that the
number of phone line (communication) faults called to the Central Station are not limited by this feature.
No subsequent restoral message is sent to the Central Station(s) for a particular trouble whose call limit has
been reached. Local DACT annunciation will still track the particular trouble and restoral.
TROUBLE CALL LIMIT
RANGE 00-99 TROUBLES
Backup Reporting Screen
The FACP can be programmed remotely from a PC using a modem and telephone line. Information can
also be retrieved from the FACP using the same method. The Upload/Download option allows an operator
to set the necessary parameters to allow the uploading and downloading of data between the FACP and PC.
The Service Terminal selection provides the means for entering these parameters.
LT1 LR1
LT2 LR2
ET32 ER32
ET33 ER33
ET34 ER34
ET35 ER35
ET101 ER101
ET102 ER102
ET103 ER103
ET104 ER104
YP
YC1 YK1
YC2 YK2
VT
ET61 ER61
ET
YF
LB
RP
RP99
OU
RB
RS
RS
RU
ET
OU
GF505 & GF510 Manual — P/N 53164:B5 6/12/2018
Master Programming Level
YQ
VR
ER
000
LX
000
000
OV
000
000
000
000
ER
OV