Specifications - Makita TW008GM201 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Fastening capacities
Square drive
No load speed
Impacts per minute
Overall length (with battery cartridge BL4040)
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for fastening bolts and nuts.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-2:
Model TW007G
Sound pressure level (L
Sound power level (L ) : 108 dB (A)
WA
Uncertainty (K) : 3 dB(A)
Model TW008G
Sound pressure level (L
Sound power level (L ) : 108 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
Standard bolt
High tensile bolt
Max impact mode (4)
Hard impact mode (3)
Medium impact mode (2)
Soft impact mode (1)
Max impact mode (4)
Hard impact mode (3)
Medium impact mode (2)
Soft impact mode (1)
) : 97 dB(A)
pA
) : 97 dB(A)
pA
TW007G
D.C. 36 V - 40 V max
BL4020* / BL4025* / BL4040* / BL4050F
* : Recommended battery
DC40RA / DC40RB / DC40RC
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the tool is
used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-2:
Model TW007G
Work mode: impact tightening of fasteners of the maxi-
mum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
5 ENGLISH
TW008G
M10 - M24
M10 - M16
12.7 mm
-1
0 - 2,300 min
-1
0 - 1,900 min
-1
0 - 1,200 min
-1
0 - 600 min
-1
0 - 2,900 min
-1
0 - 2,700 min
-1
0 - 1,900 min
-1
0 - 1,200 min
170 mm
2.7 - 3.3 kg
2
) : 19.7 m/s
h
2