Makita MJR300T Instruction Manual page 5

1
014350
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger, push in
the lock button and then release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing the saw blade for
Model MJR300T
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade, blade clamp and/or slider.
Failure to do so may cause insufficient tightening
of the blade, resulting in a serious injury.
2
3
1
014351
To install the saw blade, always make sure that the
blade clamp lever is in released position
insulation cover before inserting the saw blade. If the
blade clamp lever is in fixed position, rotate the blade
clamp lever in the direction of the arrow so that it can be
locked at the released position .
CAUTION:
If you do not insert the saw blade deep enough,
•
the saw blade may be ejected unexpectedly during
operation. This can be extremely dangerous.
1. Switch trigger
2
2. Lock button
1. Blade clamp
sleeve
2. Fixed position
3. Released position
on the
Keep hands and fingers away from the lever
•
during the switching operation. Failure to do so
may cause personal injuries.
1
014352
Insert the saw blade into the blade clamp as far as it will
go. The blade clamp lever rotates and the saw blade is
fixed. Make sure that the saw blade cannot be extracted
even though you try to pull it out.
1
014353
To remove the saw blade, rotate the blade clamp lever
in the direction of the arrow fully. The saw blade is
removed and the blade clamp lever is fixed at the
released position .
NOTE:
If you remove the saw blade without rotating the
•
blade clamp lever fully, the lever may not be
locked in the released position
rotate the blade clamp lever fully again, then make
sure that the blade clamp lever locked at the
released position .
If the lever is positioned inside the tool, switch on
•
the tool just a second to let the blade clamp out.
Switch off and unplug the tool from the mains
before working on the blade clamp lever.
Installing or removing the saw blade for
Model MJR300
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade, blade clamp and/or slider.
Failure to do so may cause insufficient tightening
of the blade, resulting in a serious injury.
5
1. Blade
1. Blade clamp lever
. In this case,