Table of Contents
Advertisement
Use Ping to Test the LAN Path to Your Gateway
You can use ping to verify that the LAN path to your modem router is set up correctly.
To ping the modem router from a computer running Windows 95 or later:
1.
From the Windows toolbar, click the Start button and select Run.
2.
In the field that is provided, type ping and then the IP address of the modem router, as in
this example:
ping 192.168.0.1
3.
Click the OK button.
You see a message like the following:
Pinging <IP address> with 32 bytes of data
If the path is working, you see this message:
Reply from < IP address >: bytes=32 time=NN ms TTL=xxx
If the path is not working, you see this message:
Request timed out
If the path is not working correctly, you could have one of the following problems:
•
Wrong physical connections.
-
Make sure that the LAN LED is lit. If this LED is off. for more information, see
LEDs to Troubleshoot
-
Check the corresponding link LEDs are on for your network interface card and the
hub ports (if any) that are connected to your workstation and modem router.
•
Wrong network configuration.
-
Verify that the Ethernet card driver software and TCP/IP software are both
installed and configured on your computer or workstation.
-
Verify that the IP address for your modem router and your workstation are correct
and that the addresses are on the same subnet.
Use Ping to Test the Path from a Windows Computer to a
Remote Device
After verifying that the LAN path works correctly, test the path from the Windows computer to
a remote device.
To test the path from a Windows computer to a remote device:
1.
From the Windows toolbar, click the Start button and select Run.
where <IP address> is the IP address of a remote device such as the DNS server of your
ISP.
N300 WiFi Cable Modem Router Model C3000
on page 96.
Troubleshooting
98
Use
Advertisement
Table of Contents
