Table of Contents
Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Armature, Spiral bevel gear [small one] (cont.)
DISASSEMBLING
(2) Disassemble the commutator end of Armature as drawn in Fig. 3.
Note: This step is required for the models with electronic control system of GA4040C, GA4540C, GA5040C,
GA6040C, GA4542C, GA5042C, GA6042C.
Fig. 3
1. Pick up three tabs of
Self lock 6 with tweezers
to remove it from Armature.
3. Remove Ball bearing 627DDW with 1R269.
1R269
Ball bearing 627DDW
ASSEMBLING
(1) Assemble small Spiral bevel gear to Armature end by reversing the disassembly procedure. (Refer to Fig. 2)
(2) Assemble the commutator end of Armature as drawn in Fig. 4.
Note: This step is required for the models with electronic control system of GA4040C, GA4540C, GA5040C,
GA6040C, GA4542C, GA5042C, GA6042C.
Fig. 4
1. Return tabs of Self lock 6 to their
normal shape before assembling.
Then, mount Wave washer 6 to
the commutator end of Armature.
Note: Be careful to their directions.
Refer to the drawings in Fig. 4.
Self lock 6
Magnet sleeve
Wave washer 6
2. Remove Magnet sleeve,
Tabs
Self lock 6
Tweezers
4. Remove Flat washer 7 and
2. Press down Self lock 6 until
Wave washer 6 gets flat.
Wave washer 6 and
Labyrinth rubber ring 22.
Magnet sleeve
Wave washer 6
Labyrinth rubber ring 22
Insulation washer.
Flat washer 7
Insulation washer
3. Magnet sleeve is stabilized
between Self lock 6 and
Wave washer 6 by the reaction
force of Wave washer 6.
P 4/ 12
Self lock 6
Magnet sleeve
Wave washer 6
Advertisement
Table of Contents
