Installation; Functional Description - Makita LS1040S Instruction Manual

INSTALLATION

Installing auxiliary plate
2
3
012658
1 2
3 4
001832
Install the auxiliary plate using the notch in the tool's base
and secure it by tightening the hex bolt.
Installing the holders
1
012653
3
012652
Install the holders on both sides of the base and secure
them with screws.
Adjust the adjusters so that they contact the floor surface.
NOTE:
In some countries, the holders may not have feet.
1. Auxiliary plate
2. Hex bolt
1
3. Base
1. Auxiliary plate
2. Base
3. Hex bolt
4. Nut
1. Holder
1. Holder
2. Adjuster
1
3. Screw
2
Bench mounting
When the tool is shipped, the handle is locked in the
lowered position by the stopper pin. Release the stopper
pin by lowering the handle slightly and pulling the stopper
pin.
001792
This tool should be bolted with two bolts to a level and
stable surface using the bolt holes provided in the tool's
base. This will help prevent tipping and possible injury.
001856

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Blade guard
001860
When lowering the handle, the blade guard rises
automatically. The guard is spring loaded so it returns to
its original position when the cut is completed and the
handle is raised. NEVER DEFEAT OR REMOVE THE
BLADE GUARD OR THE SPRING WHICH ATTACHES
TO THE GUARD.
In the interest of your personal safety, always maintain
the blade guard in good condition. Any irregular
6
1. Stopper pin
1
1. Bolt
1
1. Blade guard
1