Uncertainty (K) : 3 dB (A) The noise level under working may exceed 80 dB (A). Makita Corporation responsible manufacturer declare that the following Makita Model DFS451 machine(s): Designation of Machine: Sound pressure level (L ) : 71 dB (A)
Page 3
Europe who is: Keep cord away from heat, oil, sharp edges or Makita International Europe Ltd. moving parts. Damaged or entangled cords Michigan Drive, Tongwell, increase the risk of electric shock.
Power tool use and care Service 17. Do not force the power tool. Use the correct 28. Have your power tool serviced by a qualified power tool for your application. The correct repair person using only identical replacement power tool will do the job better and safer at the parts.
If electrolyte gets into your eyes, rinse them FUNCTIONAL DESCRIPTION out with clear water and seek medical attention right away. It may result in loss of your eyesight. CAUTION: Do not short the battery cartridge: Always be sure that the tool is switched off and the •...
Page 6
When the tool is overloaded: Pull the switch trigger to light up the lamp. The lamp • At this time, release the switch trigger, keeps on lighting while the switch trigger is being pulled. remove the battery cartridge and remove The lamp goes out 10 -15 seconds after releasing the causes of overload and then pull the switch trigger.
Hook 1. Locator 3 mm 1. Groove 2. Hook 3. Screw 011815 Adjust the locator so that the distance between the tip of 011821 the locator and the screw head is approximately 3 mm The hook is convenient for temporarily hanging the tool. as shown in the figures.
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Phillips Insert bits • Magnetic bit holder • Various type of Makita genuine batteries and •...
Page 12
Makita Corporation Anjo, Aichi, Japan www.makita.com 885267-225...