Makita DUR181RT Technical Information page 10

W
iring diagram
Fig. D-5
While facing the wire connecting portion
to Pipe 25 side, connect the Lead wire
(black) to Terminal. And then, connect Lead
wires (red, yellow) to Terminal.
Fig. D-6
Pass Lead wires (red, yellow) between Terminal
and Switch through the space between Rib A
and Rib B.
Pass Lead wire (yellow) through the space
between Rib A and Rib C.
Rib A
Lead wire (red)
Rib C
Terminal
DUR141, DUR181
Wiring to Terminal
Lead wire
(black)
Wire connecting portion
Pipe 25 side
Handle (L) side
Wiring in Handle (L)
LED warning lamp
Switch
Rib B
Lead wire
(red)
Put LED warning lamp's lead wire (red)* on
its lead wire (black) and insert them into
the groove in Handle (L).
*using Lead wire (white) for some countries
Rib
Power supply cord unit
Rib
Sheath
1. Come out at least 5 mm long portion of
Power supply cord unit from the lower
edge of Labyrinth figured lead holders.
But the sheath end must not go over Rib A.
2. Make sure that Power supply cord unit is
fixed in Labyrinth figured lead holders.
P 10/ 10
Lead wire
(Yellow)
Terminal
at least
5 mm