Buffalo CR886 Instruction Manual page 10

UK
Fault
Burner will not light Gas issues
using ignitor
Trying to light wrong burner
Burner not engaged with
control valve
Obstruction in burner
No gas flow
Vapour lock at coupling nut
to LP bottle
Coupling nut ad LP bottle
valve not fully connected.
Electrical issues
Burner will not light
using ignitor
Electrode cracked or broken;
"sparks at crack"
Electrode tip not in proper
position
Wire and/or electrode
covered with cooking residue
Wires are loose or
disconnected
Wires are short-circuited
(sparking) between ignitor
and electrode
Push button sticks at bottom
sparking between ignitor and
electrode
Sudden drop in gas Grease buildup
flow or low flame
Excessive fat in meat
Excessive cooking
temperature
Flames blow out High or gusting winds
Low on LP gas
Excess flow valve tripped
Persistent grease Grease trapped by food
fire buildup around burner system
Flashback... (fire in Burner and burner tubes are
burner tube(s) blocked
10
CR886_UK_A5_v2_20190515.indb 10
Probable Cause
Lighting the gas griddle
Make sure valve are positioned inside of burner
tubes
Ensure burner tubes are not obstructed with
spider webs or other objects (
& maintenance)
Make sure LP bottle is not empty. If not empty, see
"Sudden drop in gas flow"
Turn off knobs and disconnect coupling nut from
LP bottle. Reconnect and retry
Turn the coupling nut approximately one-half to
three-quarters
Replace electrode
Tip of electrode should be pointing toward port
hole in burner. The distance should be 1/8" to
3/16". Adjust if necessary
Clean wire and or electrode with rubbing alcohol
and clean swab
Reconnect wires or replace electrode/wire
assembly
Replace ignitor wire or ignitor
Inspect wire insulation and proper connection.
Replace wires if insulation is broken
Clean burners and inside of griddle/ firebox
Trim fat from meat before grilling
Set the control knob to a lower setting
Move the griddle to prevent it from facing wind
directly or increase flame height
Refill LP bottle
Sudden drop in gas flow
Turn all knobs to OFF. Turn gas off at LP bottle.
Let fire burn out. After griddle cools, remove and
clean all parts
Turn all knobs to OFF. Clean burner and/or burner
tubes (
Solution
Cleaning, care
Cleaning, care & maintenance)
2019/5/15 17:27