Operation - Makita DTL061Z Instruction Manual

For tool without sleeve to retain the bit
Fig.8
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
Use insert bits shown in the figure. To install the bit, just
insert it into the spindle.
Fig.9
NOTE:
If the bit is not inserted deep enough into the sleeve,
•
the sleeve will not return to its original position and
the bit will not be secured. In this case, try
re-inserting the bit according to the instructions
above.
Hook (Accessory)
CAUTION:
When installing the hook, tighten the screw firmly.
•
Failure to do so may cause the breakage of the tool
or personal injury.
Fig.10
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
Adjusting the angle head
The angle head can be adjusted 360°(8 positions in
45-degree increments). To adjust it, loosen the hex bolt
and remove the angle head.
Adjust the angle head to the desired position and reinstall
it so that the teeth on the housing will match up with the
grooves in the angle head. Then tighten the hex bolt to
secure the angle head.
Fig.11
Fig.12
Straight head and ratchet head (Accessory)
Straight heads and ratchet heads are available as
optional accessories for various applications on the job.
Fig.13
Fig.14

OPERATION

N m
(kgf cm)
50
(510)
40
(408)
30
(306)
20
(204)
10
(102)
0
0
Fastening time
008339
N m
(kgf cm)
40
(408)
30
(306)
20
(204)
10
(102)
0
0
Fastening time
008340
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. Before starting your job,
always perform a test operation to determine the proper
fastening time for your screw.
Fig.15
NOTE:
Use the proper bit for the head of the screw/bolt
•
that you wish to use.
Hold the tool pointed straight at the screw.
•
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
1. When the battery cartridge is discharged almost
completely, voltage will drop and the fastening
torque will be reduced.
6
Standard bolt
M12
(M12)
M10
(M10)
M8
(M8)
1
3
2
(S)
High tensile bolt
M8
(M8)
M6
(M6)
1 2 3
(S)