Page 1
TURBO HD D7T Series Bullet Camera User Manual UD00387B User Manual Thank you for purchasing our product. If there are any questions, or requests, please do not hesitate to contact the dealer. This manual applies to the models below: Type...
Privacy Notice Surveillance laws vary by jurisdiction. Check all relevant laws in your jurisdiction before using all this product for surveillance purpose to ensure that your use of this product conforms. Regulatory Information FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules.
Page 3
1 Introduction 1.1 Product Features This series of camera adopts high performance sensor and advanced circuit board design technology. It features high resolution, low distortion, and low noise, etc. It is suitable for surveillance system and image process system. The main features are as follows: ...
2 Installation Before you start: Please make sure that the device in the package is in good condition and all the assembly parts are included. Make sure that all the related equipment is power-off during the installation. Check the specification of the products for the installation environment.
Page 5
4. Connect the corresponding cables. 5. Adjust the camera according to Figure 2-3 to get an optimum angle. 1). Loosen the P screw to adjust the pan direction [0°~360°]. Tighten the screw after completing the adjustment. 2). Loosen the T screw to adjust the tilt direction [0°~180°].
Page 6
Screw Figure 2-5 Fix the Camera to the Ceiling 5. Connect the corresponding cables and install the gang box cover with fixing screws. Figure 2-6 Fix the Camera to the Ceiling/Wall 6. Refer to step 5 of 2.1.1 to adjust the camera to get an optimum angle.
Page 7
4. Connect the corresponding cables. 5. Adjust the camera according to Figure 2-9 to get an optimum angle. 1). Loosen the P screw to adjust the pan direction [0°~360°]. Tighten the screw after completing the adjustment. 2). Loosen the T screw to adjust the tilt direction [0°~180°].
3. Drill the screw holes in the ceiling/wall according to the supplied drill template. 4. Hammer the supplied screws into the screw holes to fix the gang box to the ceiling/wall. Screw Figure 2-12 Fix the Camera to the Ceiling 5.
3.1 Format Move the cursor to FORMAT, and press the menu button to enter the FORMAT sub menu. You can set the format of camera and confirm. 3.2 Main Menu 3.2.2 AE (Auto Exposure) AE describes the brightness-related parameters. You can adjust the image brightness by the BRIGHTNESS, EXPOSURE MODE, and GAIN in different light conditions.
In ATW mode, white balance is being adjusted automatically according to the color temperature of the scene illumination. You can set the R GAIN/B GAIN value from 0 to 255 to adjust the shades of red/blue color of the image. MODE R GAIN B GAIN...
CONTRAST This feature enhances the difference in color and light between parts of an image. You can set the CONTRAST value from 1 to 10. SHARPNESS Sharpness determines the amount of detail an imaging system can reproduce. You can set the SHARPNESS value from 1 to 10.