Advanced Settings - Cisco SE680 WiMAX User Manual

Advanced Settings

In the Advanced Settings menu, you can configure all the options for the SE680
WiMAX. If required, you can also change the settings you made using the Basic Setup
Wizard. The following table contains the options available in this menu.
Menu
Operating Mode
Internet
Local Network
WiMAX configuration
Administration
All Advanced Settings pages contain Ok and Cancel buttons.
Click Ok to confirm your entries.

Click Cancel to close a page without applying the changes.

i
Depending on the pre-configuration of your device some of the menu
entries and configuration possibilities might be missing in your device.
Description
Here you can define whether your SE680 WiMAX will be
used as a router or a bridge for the Internet access
(page 24).
Here you can configure your Internet access. This menu
covers all setting options for the Internet (page 25).
Here you can configure your local network, e.g. change the
private IP address of the SE680 WiMAX or make settings
for the DHCP server (page 29).
Here you can change the access data for your WiMAX
access (page 30).
Here you can do various administration tasks, e.g. assign a
system password (page 31) or reset the configuration to the
factory defaults (page 32). You can also load new firmware
(page 33)
Advanced Settings
23