Specifications - Makita M2400 Instruction Manual

ENGLISH (Original instructions)
1. Base
2. Bolt holes
3. Lock button / Lock-off button
4. Switch trigger
5. Stopper plate
6. Socket wrench
7. Guide plate
8. Move
9. Hex bolts
10. Shaft lock
11. Wheel guard

SPECIFICATIONS

Wheel diameter
Hole diameter
No load speed (min
Dimensions (L x W x H)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
..... Read instruction manual.
.................. DOUBLE INSULATION
Intended use
The tool is intended for cutting in ferrous materials with
appropriate abrasive cut-off wheel. Follow all laws and
regulations regarding dust and work area health and
safety in your country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
4
Explanation of general view
12. Loosen
13. Tighten
14. O-ring
15. Inner flange
16. Ring
17. Spindle
18. Cut-off wheel
19. Outer flange
20. Hex bolt
21. Vise plate
22. Vise nut
Model
-1
)
Net weight
Safety class
Save all warnings and
END201-7
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
ENE007-3
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
ENF002-2
operating a power tool. Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
GEA005-3
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
the risk of electric shock.
23. Vise handle
24. Spacer block
25. Straight piece of wood (Spacer)
26. Over 85 mm long
27. Diameter of workpiece
28. Width of spacer block
29. Blocks
30. Limit mark
31. Screwdriver
32. Brush holder cap
M2400
355 mm
25.4 mm
3,800
500 mm x 280 mm x 620 mm
15.7 kg
/II