Determining Concentration Of Solution - Hitachi U-5100 Instruction Manual

3.2.1 Determining Concentration of Solution

This instrument is used for generating a calibration curve and
determining the concentration of an unknown sample, and for
entering a calibration curve factor and determining the
concentration of an unknown sample.
Guide: When auto start is specified, the system automatically
sets up the conditions and advances to the
measurement screen phase of sequence after the
power switch is turned on. For how to specify auto
start, refer to section 4.5..
1. Startup of This Product
Start this product. (For the starting procedure, refer to
section 2.3..)
2. Setting of Measuring Conditions
(1) Press the [MAIN MENU] key. The Main Menu screen
(Fig. 3-1) will appear. To set each condition for
quantitative calculation, press the <1> key
(Photometry) and then [ENTER] key. Or select
"Photometry" with the [▲] or [▼] key and press the
[ENTER] key.
Main Menu
^1 Photometry
2 WL Scan
3 Time Scan
4 Method Menu
^5 Data Menu
6 System Setup
7 Performance
8 Data Display
Select function. : _
(2) The Photometry screen (Fig. 3-2) appears. To set the
measuring conditions, press the <1> key (Meas.
PARAM.) and then [ENTER] key. Or select "Meas.
PARAM." with the [▲] or [▼] key and press the
[ENTER] key or [►] key.
3 - 3
Fig. 3-1 Main Menu Screen
3.2.1
CELL A