Wet/Dry Vac Assembly - RIDGID WD1245 Owner's Manual

SP6439-3 E S 8/29/06

Wet/Dry Vac Assembly

1. Line up vacuum port in top assembly
with drain cap located on the front of
the drum.
2. Place lid on top of drum with the drum
latches snug against the drum channel.
3. Be sure lid completely covers the top of
the drum so leakage does not occur.
4. Push down on top of the drum latch
areas to cause the flexible locking tabs
to hook onto the drum lip of the
channel.
WD1245
Push
Down
Pull Out
Flexible
Locking
Tab
WD1635
Drum
Channel
2:12 PM Page 7
5. Make sure that the locking tabs are
6. For WD1635, rotate both drum latches
Your new Wet/Dry Vac is ready for use.
Top Assembly
Top Assembly
Push
Down
Pull Out
Drum
Latch Tab
7
snapped in place to prevent the lid from
coming off. (See inset).
down until you hear them snap over lip
of the drum.
Out
Drum
Channel
Flexible
Locking Tab
Drum Latch
Out
Drum
Drum