Makita CS002G Instruction Manual page 12

5. After installing the circular saw blade, set the dust
case again.
4
Fig.15
► 1 . Hole on the dust case 2. Hook on the tool 3. Hook
on the latch button 4. Hole on the tool
WARNING:
BE SURE TO TIGHTEN THE HEX
BOLT SECURELY. Also be careful not to tighten
the bolt forcibly. Slipping your hand from the hex
wrench can cause a personal injury.
WARNING:
If the inner flange is removed,
be sure to install it on the spindle. When install-
ing, choose a correct side on which protrusion
fits into the circular saw blade hole perfectly.
Mounting the circular saw blade on the wrong side
can result in the dangerous vibration.
For tool with the inner flange for
other than 15.88 mm hole-diameter
saw blade
2
1
The inner flange has a certain diameter protrusion on one
side of it and a different diameter protrusion on the other side.
Choose a correct side on which protrusion fits into the saw
blade hole perfectly. Mount the inner flange onto the mounting
shaft so that the correct side of protrusion on the inner flange
faces outward and then place saw blade and outer flange.
Fig.16
► 1 . Mounting shaft 2. Inner flange 3. Circular saw
3
BOLT CLOCKWISE SECURELY. Also be careful
not to tighten the bolt forcibly. Slipping your hand
from the hex wrench can cause a personal injury.
on the inner flange that is positioned outside fits
into the saw blade hole "a" perfectly. Mounting the
blade on the wrong side can result in the dangerous
vibration.
For tool with the inner flange for a
15.88 mm hole-diameter saw blade
(country specific)
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place circu-
lar saw blade (with the ring attached if needed), outer
flange and hex bolt.
For tool without the ring
Fig.17
► 1 . Mounting shaft 2. Inner flange 3. Circular saw
12 ENGLISH
1 2
blade 4. Outer flange 5. Hex bolt
WARNING:
BE SURE TO TIGHTEN THE HEX
WARNING:
Make sure that the protrusion "a"
1 2
blade 4. Outer flange 5. Hex bolt
5
4
3
5
4
3