Makita CS002G Instruction Manual page 10

Push the latch button on the dust case to remove the
dust case. Dump the metal chips while the inside of the
dust case faces downward.
Fig.8
► 1 . Latch button
Fig.9
After dumping the metal chips, set the dust case.
Align the hole on the dust case with the hook on the
tool.
At this time, align the "I" marking as illustrated so that
you can set the dust case in the proper position.
1
Then, insert the hook on the latch button to the hole on
the tool.
4
Fig.10
► 1 . Hole on the dust case 2. Hook on the tool 3. Hook
on the latch button 4. Hole on the tool
Fig.11
► 1 . "I" marking
NOTICE:
with the holes.
10 ENGLISH
Make sure that each hook is secured
2
1
3
1