Adjusting The Miter Angle; Adjusting The Bevel Angle - Makita LF1000 Instruction Manual

Adjusting the miter angle

2
► 1. Clamping screw 2. Guide fence
2
► 1. Handle 2. Turn table
Loosen the clamping screw on the guide fence by turning counter-
clockwise. Turn the turn table by handle. When you have moved the
handle to the position where the pointer points to the desired angle on
the miter scale, securely tighten the clamping screw clockwise.
CAUTION:
• When turning the turn table, be sure to raise the
handle fully.
• After changing the miter angle, always secure the
turn table by tightening the clamping screw firmly.

Adjusting the bevel angle

In the miter saw mode
► 1. Lever
1
1
1
8 ENGLISH
► 1. Handle
To adjust the bevel angle, loosen the lever at the rear of
the tool counterclockwise.
Push the handle to the left to tilt the saw blade until the
pointer points to the desired angle on the bevel scale.
Then tighten the lever clockwise firmly to secure the
arm.
CAUTION:
• When tilting the saw blade, be sure to raise the
handle fully.
• After changing the bevel angle, always secure
the arm by tightening the lever clockwise.
In the table saw mode
1
► 1. Lever 2. Cutting depth adjusting knob
To adjust the bevel angle, loosen the lever under the
table at the front of the tool counterclockwise.
Move the depth adjusting knob to the left to tilt the saw
blade until the pointer points to the desired angle on the
bevel scale. Then tighten the lever clockwise firmly to
secure the arm.
1
2