Securing Workpiece - Makita LF1000 Instruction Manual

The use of the dust bag makes cutting operations clean and dust
collection easy. To attach the dust bag, fit it onto the dust nozzle.
When the dust bag is about half full, remove the dust bag from
the tool and pull the fastener out. Empty the dust bag of its
contents, tapping it lightly so as to remove particles adhering
to the insides which might hamper further collection.
1
2
► 1. Dust bag 2. Fastener
If you connect a vacuum cleaner to your saw, more
efficient and cleaner operations can be performed.
Elbow
1
2
► 1. Dust nozzle 2. Elbow
CAUTION:
• Point the discharge opening of the elbow to the
direction in which the exhaust dust and chips do not
fly out toward the tool and persons in work area.
Attach the elbow when changing the direction of dust
discharge.

Securing workpiece

WARNING:
• It is extremely important to always secure the
workpiece properly and tightly with the vise.
Failure to do so can cause the tool to be dam-
aged and/or the workpiece to be destroyed.
PERSONAL INJURY MAY ALSO RESULT. Also,
after a cutting operation, DO NOT raise the
blade until the blade has come to a complete
stop.
Sub-fence
The sub-fence can be installed on the guide fence.
When performing left bevel cuts or cutting as table saw
(bench mode), remove the sub-fence.
CAUTION:
• When performing left bevel cuts or cutting as
table saw (bench mode), remove the sub-fence.
Otherwise, it will contact the blade or a part of
the tool, causing possible serious injury to the
operator.
Vertical vise
2
3
4
5
► 1. Vise knob 2. Vise rod 3. Clamping screw 4. Vise
arm 5. Guide fence
The vertical vise can be installed in two positions on
either the left or right side of the guide fence. Insert the
vise rod into the hole in the guide fence and tighten the
clamping screw to secure the vise rod.
15 ENGLISH
1