Specifications - Makita LF1000 Instruction Manual

SPECIFICATIONS

Blade diameter
Blade body thickness
Riving knife thickness
Hole diameter
Max. Cutting capacities at 90°in the table saw (bench saw mode)
No load speed (min
Table size (W x L)
Dimensions (L x W x H1(note 1)/H2(note 2)) at miter saw mode
in table saw mode
Max. Cutting capacities (H x W) with blade 260 mm in diameter in the miter saw mode
Note1 H1: Height up to the tool head
Note2 H2: Height up to the table
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
DOUBLE INSULATION
Wear safety glasses.
To avoid injury from flying debris, keep hold-
ing the saw head down, after making cuts,
until the blade has come to a complete stop.
Do not place hand or fingers close to the
blade.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Unplug the tool before turning it over
around the axis.
Position hands properly when carrying.
Model
For European countries
-1
)
Net weight
Safety class
Bevel angle
0°
45° (left)
660 mm x 650 mm x 1,220 mm / 800 mm
660 mm x 650 mm x 1,060 mm / 845 mm
Do not lift up the top end of the rip fence
when installing or removing it.
To loosen the bolt, turn it clockwise.
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human
health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and its adaptation to national law,
used electrical and electronic equipment
should be collected separately and
delivered to a separate collection point
for municipal waste, operating in accor-
dance with the environmental protection
regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Intended use
The tool is intended for accurate straight and miter cutting in
wood. The tool can be used both in miter saw mode and in
table saw mode by turning over the table around its axis.
2 ENGLISH
LF1000
260 mm
1.8 mm - 2.0 mm
2.2 mm
30 mm
70 mm
2,700
500 mm x 555 mm
36 kg
/II
Miter angle
0°
20 mm x 180 mm
68 mm x 155 mm
50 mm x 150 mm