Makita DUB362 Instruction Manual page 8

Remaining battery capacity
indication
(Country specific)
► Fig.3: 1. Battery indicator 2. CHECK button
Press the check button to make the battery indicators
show the remaining battery capacities. The battery
indicators correspond to each battery.
Remaining battery capacity
indication
Battery indicator status
Blinking
On Off
Switch action
CAUTION:
• Before inserting the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
► Fig.4: 1. Switch trigger
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
► Fig.5: 1. Lock button
For continuous operation, pull the switch trigger, push in
the lock button and then release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed change
► Fig.6: 1. Adjusting dial
The maximum air volume can be adjusted just by
turning the adjusting dial. This can be done even while
the tool is running. The dial is marked 1 (lowest) to 6
(highest).
NOTICE:
The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
When working in a high temperature circum-
stance, the tool may be stopped because of the
overheat protection system. In that case let the
tool cool down. Avoid setting to speed 6 (highest)
in high temperature circumstances.
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing the long nozzle
► Fig.7: 1. Long nozzle 2. Triangle marking
To install the long nozzle:
1. Align the small projection of the housing with the
groove of the long nozzle.
2. Slide in the long nozzle, and turn it clockwise until
the triangle markings on the long nozzle and the
housing meet each other.
► Fig.8
The length of the nozzle can be adjusted by changing
the locking position.
Installing the flat nozzle or
extension nozzle
Optional accessory
The extension nozzle / flat nozzle can be installed on
the tip of the long nozzle in the same way as above.
Installing the gutter nozzle
Optional accessory
The gutter nozzle can be installed on the blower. The
adapter pipe designed exclusively for this model is
required to install the gutter nozzle.
For more details, refer to the instruction manual pro-
vided with the gutter nozzle.
Attaching the shoulder strap
Optional accessory
CAUTION:
When you use the tool in combi-
nation of the backpack-type power supply such
as portable power pack, do not use the shoulder
strap included in the tool package.
If you put on the shoulder strap included in the tool
package and the shoulder harness of the back-
pack-type power supply at the same time, removing
the tool or backpack-type power supply is difficult in
case of an emergency, and it may cause an accident
or injury.
► Fig.9
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy
to work with it.
8 ENGLISH