Functional Description - Makita VC2211M Instruction Manual

27. CHECK DAMAGED PARTS. Before further use
of the cleaner, a guard or other part that is
damaged should be carefully checked to deter-
mine that it will operate properly and perform
its intended function. Check for alignment of
moving parts, binding of moving parts, break-
age of parts, mounting, and any other condi-
tions that may affect its operation. A guard or
other part that is damaged should be properly
repaired or replaced by an authorized service
center unless otherwise indicated elsewhere
in this instruction manual. Have defective
switches replaced by authorized service cen-
ter. Don't use the cleaner if switch does not
turn it on and off.
28. For user servicing, the machine shall be dis-
mantled, cleaned and serviced, as far as is
reasonably practicable, without causing risk to
the maintenance staff and others.
29. The machine should be technically inspected
by the manufacturer, or an instructed person,
at least annually, consisting of, for example,
inspection of filters for damage, air tightness
of the machine and proper function of the
control mechanism.
30. When carrying out service or repair opera-
tions, all contaminated items which cannot be
satisfactorily cleaned are to be disposed of;
such items shall be disposed of in impervious
bags in accordance with any current regula-
tion for the disposal of such waste.
31. REPLACEMENT PARTS. When servicing, use
only identical replacement parts.
32. When not in use, always store the cleaner
indoors.
33. Wet filters and the interior part of the liquid
container shall be dried before storage.
34. Be kind to your cleaner. Rough handling can
cause breakage of even the most sturdily built
cleaner.
35. Do not attempt to clean the exterior or interior
with benzine, thinner or cleaning chemicals.
Cracks and discoloration may be caused.
36. Do not use cleaner in an enclosed space where
flammable, explosive or toxic vapors are given
off by oil-base paint, paint-thinner, gasoline,
some mothproofing substances, etc., or in
areas where flammable dust is present.
37. Do not leave the cleaner cord lying on the floor
after you have finished a cleaning job. It can
become a tripping hazard or may cause dam-
age to the cleaner.
38. Do not operate the cleaner or any tool while
under the influence of drugs or alcohol.
39. As a basic rule of safety, use safety goggles or
safety glasses with side shields.
40. Use a dust mask in dusty work conditions.
41. This machine is not intended for use by per-
sons including children with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge.
42. Children should be supervised to ensure that
they do not play with the cleaner.
43. Never handle plug cord or cleaner with wet
hands.
44. Use extreme caution when cleaning on stairs.
45. Do not use the cleaner as a stool or work
bench. The machine may fall down and may
result in personal injury.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
FUNCTIONAL
DESCRIPTION
WARNING:
• Before plugging the cleaner, always make
sure that the cleaner is switched off. Plugging
the cleaner with the switch on may cause an
unexpected start resulting in serious personal
injury.
Switch action
► Fig.1: 1. Suction force adjusting knob 2. Hose
diameter selection dial 3. Switch lever
To start the cleaner, rotate the switch lever to the "I"
side. To stop it, rotate the switch lever to the "O" side.
► Fig.2: 1. Suction force adjusting knob 2. Hose
diameter selection dial 3. Switch lever
The suction force can be adjusted according to your
work need.
Suction force can be increased by turning the suc-
tion force adjusting knob from the
the symbol.
Also, set the hose diameter selection dial to the hose's
diameter that you are going to use.
Hose diameter selection dial
Turn the dial direction in accordance with the hose you
use.
NOTE: Do not set the dial at the middle. Always turn
either side according to the hose diameter.
9 ENGLISH
symbol to