Operation - Makita DUB362 Instruction Manual

Overheat protection for tool
On
015485
When the tool is
automatically, the battery indicator blink about 60
seconds. In this situation, let the tool cool down before
turning the tool on again.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically. If the product does not operate even
when the switches are operated, remove the batteries
from the tool and charge the batteries.
Remaining battery capacity indication
Fig.2
Press the check button to make the battery indicators
show the remaining battery capacities. The battery
indicators correspond to each battery.
Remaining battery capacity indication
Battery indicator status
Blinking
On Off
015527
Switch action
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
Fig.3
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
Fig.4
For continuous operation, pull the switch trigger, push in
the lock button and then release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Blinking
overheated, the tool
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery
Speed change
Fig.5
The maximum air volume can be adjusted just by
turning the adjusting dial. This can be done even while
the tool is running. The dial is marked 1 (lowest) to 6
(highest).
NOTICE:
stops
The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
When working in a high temperature circumstance,
the tool may be stopped because of the overheat
protection system. In that case let the tool cool
down. Avoid setting to speed 6 (highest) in high
temperature circumstances.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing the long nozzle
Fig.6
To install the long nozzle:
1. Align the small projection of the housing with the
groove of the long nozzle.
2. Slide in the long nozzle, and turn it clockwise until
the triangle markings on the long nozzle and the
housing meet each other.
Fig.7
The length of the nozzle can be adjusted by changing
the locking position.
Installing the shoulder strap
(optional accessory)
Fig.8
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy to
work with it.

OPERATION

Blowing
Fig.9
CAUTION:
Do not place the blower on the ground while it is
•
switched on. Sand or dust may enter from suction
inlet, and they may result in personal injury.
Hold the blower firmly with a hand and perform the
blowing operation by moving it around slowly.
When blowing around a building, a big stone or a
vehicle, direct the nozzle away from them.
When performing an operation in corner, start from the
corner and then move to wide area.
7