Setup Procedure - Honeywell SC1000 Owner's Manual

14.3 Setup Procedure

If you are not familiar with operating the instrument in the SETUP menu mode,
see "SETUP Menu mode" on page 23. A listing of all menu items is given in
"Setup Menu Reference" on page 157.
Step 1: Determine if you have a Voltage DAC Output channel or a Current DAC
Output channel.
Check the instrument's Customer Information Sheet, or see "Identifying the
Output Type" on page 135.
Step 2: Wire the readout instrument to the channel's connector.
See the "Wiring" section earlier in this chapter for details.
Step 3: Select the value (channel and source) used to drive the Analog Output
See the "Channel Menu" on page 133 for details.
Step 4: Select the full-scale and zero-scale settings used to drive the Analog Out-
put.
See the "Channel Menu" on page 133 for details.
SC Series Instruction Manual page 131