Operation - Makita DHP482 Instruction Manual

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
drill bit
Optional accessory
Fig.10: 1. Sleeve 2. Close 3. Open
counterclockwise.
Installing hook
Fig.11: 1. Groove 2. Hook 3. Screw
the hook, insert it into a groove in the tool housing on
loosen the screw and then take it out.
Installing driver bit holder
Optional accessory
Fig.12: 1.
on either right or left side and secure it with a screw.

OPERATION

CAUTION:
Always insert the battery cartridge
all the way until it locks in place. If you can see the
locked completely. Insert it fully until the red indicator
you.
CAUTION:
When the speed comes down
extremely, reduce the load or stop the tool to
avoid the tool damage.
control the twisting action.
Fig.13
2.
Screwdriving operation
CAUTION:
Adjust the adjusting ring to the
proper torque level for your work.
CAUTION:
Make sure that the driver bit is
inserted straight in the screw head, or the screw
First, turn the action mode changing ring so that the
sure to the tool. Start the tool slowly and then increase the speed
gradually. Release the switch trigger as soon as the clutch cuts in.
NOTE: When driving wood screw, pre-drill a pilot hole
and prevents splitting of the workpiece.
Hammer drilling operation
CAUTION:
There is a tremendous and sudden
time of hole breakthrough, when the hole becomes
clogged with chips and particles, or when striking
reinforcing rods embedded in the concrete.
First, turn the action mode changing ring so that the arrow
then pull the switch trigger. Do not force the tool. Light
and prevent it from slipping away from the hole.
clogged with chips or particles. Instead, run the tool at
Blow-out bulb
Optional accessory
Fig.14: 1.
dust out of the hole.
Drilling operation
the
Drilling in wood
Drilling in metal
hole, make an indentation with a center-punch and
9 ENGLISH
marking.
-
-