Functional Description - Makita DHP482 Instruction Manual

FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
cartridge.
Fig.1: 1. Red indicator 2. Button 3. Battery cartridge
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
Battery protection system
Lithium-ion battery with star marking
Fig.2: 1. Star marking
Overloaded:
In this situation, turn the tool off and stop the application
the tool on to restart.
on again.
Low battery voltage:
will not operate. In this situation, remove and recharge
Indicating the remaining battery
capacity
Only for battery cartridges with "B" at the end of the
model number
Fig.3: 1. Indicator lamps 2.
light up for few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
from the actual capacity.
Switch action
Fig.4: 1. Switch trigger
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
trigger. Release the switch trigger to stop.
Lighting up the front lamp
Fig.5: 1. Lamp
CAUTION:
Do not look in the light or see the
source of light directly.
trigger.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
7 ENGLISH
Off Blinking
malfunctioned.
-
Remaining
capacity
Charge the
may have