Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita DHP482SFX5
Summary of Contents for Makita DHP482SFX5
- Page 1 INSTRUCTION MANUAL Cordless Hammer Driver Drill DHP482 Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model: DHP482 Drilling capacities Concrete 13 mm Steel 13 mm Wood 38 mm Fastening capacities Wood screw 10 mm x 90 mm Machine screw No load speed High (2) 0 - 1,900 min Low (1) 0 - 600 min Blows per minute High (2) 0 - 28,500 min... - Page 3 If operating a power tool in a damp location Use the power tool, accessories and tool bits is unavoidable, use a residual current device etc. in accordance with these instructions, tak- (RCD) protected supply. Use of an RCD reduces ing into account the working conditions and the risk of electric shock.
-
Page 4: Tips For Maintaining Maximum Battery Life
MISUSE or failure to follow the safety causing fires, personal injury and damage. It will rules stated in this instruction manual may cause also void the Makita warranty for the Makita tool and serious personal injury. charger. Tips for maintaining maximum... -
Page 5: Battery Protection System
To remove the battery cartridge, slide it from the tool Indicating the remaining battery while sliding the button on the front of the cartridge. capacity To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip Only for battery cartridges with "B"... -
Page 6: Switch Action
Switch action Reversing switch action A A A Fig.4 Fig.6 ► 1 . Switch trigger ► 1 . Reversing switch lever CAUTION: CAUTION: Before installing the battery car- Always check the direction of tridge into the tool, always check to see that the rotation before operation. -
Page 7: Adjusting The Fastening Torque
Position of Speed Torque Applicable speed operation change lever High Heavy load- ing operation High Light loading operation To change the speed, switch off the tool first. Select the "2" side for high speed or "1" for low speed but high torque. Be sure that the speed change lever is set to the correct position before operation. -
Page 8: Operation
ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit/ drill bit Optional accessory Fig.12 ► 1 . Driver bit holder 2. Driver bit Fit the driver bit holder into the protrusion at the tool foot on either right or left side and secure it with a screw. -
Page 9: Maintenance
Drilling in metal Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then To prevent the drill bit from slipping when starting a increase the speed gradually. Release the switch trigger hole, make an indentation with a center-punch and as soon as the clutch cuts in. - Page 10 If electric the carbon brushes. Take out the worn carbon brushes, brake is not working well, ask Makita Authorized or insert the new ones and replace the carbon brush caps Factory Service Centers for repair.
-
Page 11: Optional Accessories
OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regard- ing these accessories, ask your local Makita Service Center. - Page 12 Makita Corporation 885433A8 20151215 www.makita.com...