Certification; Spare Parts; Service And Repair - Honeywell HERMetic UTImeter Gtex Operation And Service Manual

3.5

Certification

Enraf Tanksystem SA is
an ISO 9001 certified
company by QMI and
MED-D by Det Norske
Veritas Certification
GmbH.
The equipment has been approved for the
electrical intrinsic safety
authorities :
IECEx
Zone 0 Ex ia IIB T4 20°C < Ta < +50°C
Standards used:
IEC 600790, Fourth Edition 200401,
IEC 6007911, Fifth Edition 200607
IEC 6007926, First Edition 200403
ATEX
II 1 G EEx ia IIB T4 / Tamb. 50 °C
Standards used:
EN50014, (1997) + Amds 1 & 2
EN50020, (2002)
EN50284, (1999)
Regarding product compliance against standards
updates or new standards, please refer to the
Declaration of conformity.
Factory Mutual (FM Approvals)
CL I, DIV 1, GP C&D, T4
CL I, ZN 0, AEx ia IIB T4
The equipment has been approved as oil/water
interface detector
Resolution MEPC.5(XIII) of 13 June 1980 by
National Maritime Authorities and/or Classification
Societies.
If you need a copy of any of these certificates
please contact:
Enraf Tanksystem SA
Rue de l'industrie 2
1630 Bulle, SWITZERLAND
Telephone : +41-26-91 91 500
Telefax : +41-26-91 91 505
Web site : www.tanksystem.com
E-mail : tanksystem@honeywell.com
50461/GTEX MMC/1111
by the following
Tamb. 50 °C and
Tamb. 50 °C
according to MARPOL
3.6

Spare parts

When ordering spares identify the spare part by
TS number and description. Refer to section
"Drawings".
Some spares might be repairable; in this case
send the part(s) to any authorised service center
or to the factory.
In case of urgency, complete replacement units
can be made available. Contact the factory or
nearest Service Station for details.
3.7

Service and Repair

The customer is responsible for any freight and
customs clearance charges. If units are sent on a
"freight collect" the charges will be invoiced to the
customer.
When returning units or parts for repair to the
factory please fill out a service request form (see
next page). The serial number (letter "G" followed
by 5 digits) is printed on the identification plate as
shown on the Figure 2-1.
When returned to Enraf Tanksystem SA
equipment must be contamination-free. If it is
determined that the customers equipment is
contaminated, it will be returned to the
customer at
Contaminated equipment will not be repaired
until such time
decontaminates the said equipment.
6
the customers expense.
that the customer
UTImeter Gtex MMC