Makita GA4040C Instruction Manual page 9

1
► 1. Arrow 2. Notch
NOTE:
• Ezynut can be loosened by hand as long as
the arrow points the notch. Otherwise a lock
nut wrench is required to loosen it. Insert one
pin of the wrench into a hole and turn Ezynut
counterclockwise.
Installing or removing flex wheel
(optional accessory)
WARNING:
• Always use supplied guard when flex wheel is
on tool. Wheel can shatter during use and guard
helps to reduce chances of personal injury.
► 1. Lock nut 2. Flex wheel 3. Plastic pad 4. Inner
flange
Follow instructions for depressed center wheel but also
use plastic pad over wheel. See order of assembly on
2
accessories page in this manual.
Installing or removing abrasive disc
(optional accessory)
NOTE:
•
► 1. Sanding lock nut 2. Abrasive disc 3. Rubber pad
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the sanding lock nut onto the
spindle. To tighten the sanding lock nut, press the shaft
lock firmly so that the spindle cannot revolve, then use
the lock nut wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
Installing or removing dust cover
attachment (Optional accessory)
•
There are four pieces of dust cover attachment and
each is used in one of different positions.
1
2
3
4
► 1. Marking A 2. Marking B 3. Marking C
9 ENGLISH
Use sander accessories specified in this man-
ual. These must be purchased separately.
WARNING:
Always be sure that the tool is switched off
and unplugged before installing or removing
the dust cover attachment. Failure to do so
causes damage to the tool or a personal injury.
1
3
4. Marking D
1
2
3
2
4