ABB OMD800 Installation And Operating Instruction page 52

52
A U T O M AT I C C O N T R O L U N I T, O M D 8 0 0
Clear log does not have its own page. The log is cleared when Clear Log is chosen and the Enter key is
pressed. Alarms must be reset when clearing alarms/events.
Diagnostics
Measured Values
Alarm/Event Log
Counters
SW: 2A1 SN: 0
Alarm/Event Log
View Log
Clear Log
Figure 7.49 Alarm/Event Log: View Log will show 50 latest alarms and events, Clear Log will
empty the log
Counters
On this page the summary of switching operations is shown. One operation is from I to O or from II to O
or from O to I or from O to II, eg. the total summary of the operations from I to II is two operations. Re-
turn back to Diagnostics menu by pushing the ESC key.
Diagnostics
Measured Values
Alarm/Event Log
Counters
SW: 2A1 SN: 0
Figure 7.50 Counters page will show the summary of operations
Generator Control
On this page the user can start or stop the generator if generator is in use (see the selection of
"Generator Usage" in Section 7.2.2.3). Start and Stop commands are given with UP and DOWN arrow
keys. OMD800 must be on Manual mode when starting the generator manually.
Return back to Diagnostics menu by pushing the ESC key.
Diagnostics
Alarm/Event Log
Counters
Generator Control
SW: 2A1 SN: 0
Figure 7.51 Generator Control if generator is in use
2/6
2/2
Alarm/Event Log
View Log
Clear Log
3/6
Counters
OPERATIONS: 0
Return
Generator Control
4/6
GENERATOR STARTED
Return
1/2
GENERATOR STOPPED
Stop
Start
Alarm/Event Log
Return Browse
Generator Control
Return
Start
(0)
Stop