Cisco Firepower 4110 Manual page 21

Installation, Maintenance, and Upgrade
a) Locate the hexagonal ventilation hole on the power supply module at the center of the plug just below the power
connector body (see the following figures).
b) Plug the snapping portion of the tie wrap into the hexagonal hole.
c) With the clamp side facing up, push the tie wrap in until it is fully engaged.
Caution Make sure you have the correct location because you cannot remove the tie wrap from the power supply
module once you have installed it without damaging the tie wrap.
Figure 12: Flextronics Power Supply Module
1 Flextronics tie wrap
Figure 13: Artesyn Power Supply Module
1 Artesyn tie wrap
Secure the Power Cord on the AC Power Supply Module
2 Hexagonal hole
2 Hexagonal hole
Installation, Maintenance, and Upgrade
21