Table of Contents
Advertisement
3.3
FFT-24 Installation
The FFT-24 expander board lets you add additional zones to the SK-FFT. To add
Zone 25 - Zone 48 to the SK-FFT, you must use FFT-24 expander board.
To install the FFT-24:
1. Open Cabinet door and dead front panel.
2. Remove power. See Appendix A for compatible powering devices.
3. Remove blank plate and discard.
4. Mount the FFT-24 on the six mounting studs located on the inside of the dead front
panel and secure using the nuts removed from the blank plate. See Figure 3-7.
Mounting
Studs
5. Connect one end of the wiring harness (P/N 130398 supplied) to the SK-FFT and
54711
Figure 3-7 Mounting locations for the FFT-24
Installation
Mounting
Studs
3-5
Advertisement
Table of Contents
