Flush Mounting - Honeywell SILENT KHIGHT SK-FFT Installation And Operation Manual

SK-FFT Installation and Operation Manual
3.1.2

Flush Mounting

This section describes how to flush mount the cabinet into a wall. To recess mount
the cabinet you will need to have the optional trim ring P/N VIP-TR (ordered
separately).
Follow these steps to recess mount the cabinet:
1. Remove the cabinet door and the dead front panel.
2. Cut a recess hole 20-1/4" W x 26-3/4" H (51.44 cm W x 67.95 cm H). There
should be 1.5" to 1.75" of cabinet extruding from the wall, this should be measured
from either the top edge or bottom edge to the exterior side of the sheet rock. (See
Figure 3-2.)
Do not insert the cabinet deeper than recommend above. If the cabinet is mounted to deep you will
not be able to re-attach the door assembly.
3. Mount the cabinet to wall studs by inserting a screw through the cabinets side
mounting holes into the wall stud.
Trim Ring
Trim Ring
Mounting
Hole
Side View of Cabinet
and Trim Ring
3-2
Important!
Cabinet
Mounting Hole
Trim Ring
Mounting
Hole
Figure 3-2 Detail of Flush Mounting with Trim Ring
Sheet Rock
1.5 to 1.75"
Mounting
Studs
Cabinet
Mounting Hole
Sheet Rock
54711