Applying Grease - Canon QY8-1360-000 Service Manual

BJC-7100

3. APPLYING GREASE

Apply the MOLYKOTE PG641 greases at the points shown below.
Smear a thin film of the appropriate amount of grease smoothly over the whole area to be
lubricated.
MOLYKOTE PG641
Surfaces of Pinion
Gear Teeth
(approx. 30mg)
Dubble Gear Side Surface
(approx. 10mg in each of 2 locations)
The BJC-7100 uses three types of grease. Only apply the specified grease
to the specified locations.
Never apply grease to locations other than those indicated. Also take care
that grease does not get onto parts neighboring the indicated locations.
Rib Face (approx. 3mg)
Shaft Gliding Surface
(approx. 12mg)
Carriage Slider
Figure 5-1 Grease Points
Cam Gliding Surface
(approx. 24mg)
Around
Entire Shaft
(approx. 320mg)
Bottom Shaft Gliding Surface
(approx. 20mg in each of 2 location)
Inside of Shaft (approx. 12mg)
Between Gears and Transmission Arm
(approx. 30mg)
5-3
Part 5: Maintenance
Gliding Surface
(approx. 24mg)
Gear Teeth
(approx. 24mg
per gear)
Shaft
(approx. 12mg)