Assembling The Chassis - Canon QY8-1360-000 Service Manual

BJC-7100

4.4 Assembling the Chassis

Follow the procedure below to tighten the following screws (total 9 screws securing
front chassis unit and rear chassis) after you have replaced parts.
1) When both the front chassis unit and rear chassis have been removed from the body,
fit the rear chassis onto the body first.
2) After you have fitted the front chassis unit and rear chassis onto the body, attach the
nine screws. When you start attaching the screws, leave them in a loose state.
3) First, tighten two screws (A) on the front of the front chassis unit. Before you tighten
these screws, make sure that the bosses to the outside of these screws are properly
fitted in place.
4) Alternately tighten four screws (1) (2) (3) and (4) on both ends of the front chassis
unit.
5) Tighten three screws (5) (6) and (7) on the rear chassis in that order.
6) Firmly tighten all screws again.
2
6
4
7
A
Bosses
Figure 5-8 Tightening the Chassis Fixing Screws
5
A
3
1
Rear Chassis
Front Chassis Unit
5-7
Part 5: Maintenance