Table of Contents
Advertisement
DAP-1360U Wireless N300 Access Point & Router
User Manual
Parameter
Protocol
Set as
Start IPv4 address
End IPv4 address
Subnet IPv4 address
Set as
Start IPv4 address
End IPv4 address
Subnet IPv4 address
Destination port
Set source port
manually
Source port
Click the APPLY button.
A protocol for network packet transmission. Select a value from the
drop-down list.
Source IP address
Select the needed value from the drop-down list.
The source host start IPv4 address.
If it is necessary to specify a single address, leave the End IPv4
address field blank.
You can choose a device connected to the access point's LAN at the
moment. To do this, select the relevant IPv4 address from the drop-
down list (the field will be filled in automatically).
The source host end IPv4 address.
The source subnet IPv4 address. The field is displayed when the
Subnet value is selected from the Set as drop-down list.
Destination IP address
Select the needed value from the drop-down list.
The destination host start IPv4 address.
If it is necessary to specify a single address, leave the End IPv4
address field blank.
You can choose a device connected to the access point's LAN at the
moment. To do this, select the relevant IPv4 address from the drop-
down list (the field will be filled in automatically).
The destination host end IPv4 address.
The destination subnet IPv4 address. The field is displayed when the
Subnet value is selected from the Set as drop-down list.
Ports
A port of the destination IP address. You can specify one port,
several ports separated by a comma, or a range of ports separated by
a colon.
Move the switch to the right to specify a port of the source IP
address manually. Upon that the Source port field is displayed.
A port of the source IP address. You can specify one port, several
ports separated by a comma, or a range of ports separated by a colon.
Page 130 of 158
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
